How to get water out of Charging port? – 15 Easy ways


Most of the latest phones are water-resistant and aren’t damaged by moisture. But when moisture enters the phone charging port and remains for a while, it is a red flag and quick action is required on the part of the owner.  There is nothing to worry about as there are plenty of ways to dry the phone’s charging port.

To get the water out of the charging port, turn the phone off and gently shake it while keeping the lightning connector facing downwards. Place a towel against the lightning port to soak up the water. Ensure you press firmly on the port.

All the high-end phones are expensive and have a limited warranty. Many brands have a water damage warranty but for a limited period. Therefore phone owners should find ways to remove the mixture from their charging ports without voiding the warranty and permanent damage to their phones. 

This article will explain how to get water out of the phone’s charging port. And what steps are needed for drying it completely? It also covers tips for preventing the device from damaging and saving the cost of repairing.

How To Get Water Out Of Phone Charging Port Quickly?

The vital first step is turning the phone off until the water is completely gone.

After that, start by removing SIM cards or memory cards and battery(if possible) or power source from your device to avoid damage.

Then use any of these 15 simple ways to dry your charging port.

1. Use a toothpick to remove debris

Use a toothpick to get water out of the phone charging port.

The Smartphone USB port is compact. Use a toothpick or a needle or paper pin to scoop the water out of the lightning port. 

Now gently tap the phone with the charging port facing the ground.

Turn the phone on.

If you don’t see any moisture warning message, you are good to use your smartphone.

2. Use kitchen tissue

Kitchen tissue papers are made for soaking water and oil. They have a high liquid absorbing property. Use the corner of the kitchen tissue and insert it inside the phone charging port. Keep it there for at least 5 seconds. Take the corner out, if it is wet this method is working.

Repeat this process with a new corner every time. Tear the paper into small pieces if you have to repeat this process multiple times(at least till the corner comes out wet every time)

3. Use a syringe to suck the water out

A syringe with a small needle can suck the water out. But this method requires extreme caution as the needle might break the port.

4. Use compressed air

Try using compressed air to clean out your charging port (be careful not to push anything further in). 

Make sure of any debris near the face of the charging port, then use a compressed air can with a straw to force the pressure in and debris out.

It is one of the quickest ways to get water out of the USB charging ports. And the best way to clean it.

This point helps save the phone charging port if the amount of water in the charging port is high.

Although this won’t help you take moisture out of the phone charging port or the phone itself, it will remove the bulk of the water from the phone’s charging port.

You can repeat this process many times till you think the phone’s charging port is safe to use. For moisture, use any of the processes mentioned in the following easy ways.

5. Contact customer support(From another device)

When all else fails, the best solution is to take the device into the store to request service or replacement. Any parts that may have become defective or broken due to liquid exposure.

For an android device, check with your phone customer support about the service and warranty. Warranty and service conditions vary from brand to brand.

Use an alternate phone borrowed from a family member or friend.

Don’t turn your phone on to make the call. Never use the phone’s charging port in any way(don’t connect any lightning accessory) before talking to customer support.

6. Wrap with a paper towel

Get some tape or paper towel and wrap it tightly around the port.

Paper towels have an instantaneous water-absorbing ability. You might need to use different portions of a single paper towel.

Softer paper towels get folded into pointed edges. And these edges can go deep into the charging port or USB port to get water out.

Keep repeating till the edge of the paper towel comes out dry.

7. Vacuum suction

Take a vacuum cleaner to suck all the water out of the device.

Place the vacuum hose exactly attached to the surface of the device with the charging port directly facing the hose.

This method is most effective if the phone gets soaked in liquid.

8. Cotton swab or cloth

Use a cotton swab or a soft cloth to soak up any remaining water inside the lightning port.

Place the cotton swab or the cloth on the face of the phone’s charging port. Press the cotton swab on the opening of the lightning port. Contact should be as tight as possible. 

Repeat this process two to three times with multiple swabs.

Cotton is a highly absorbent material. The water droplets get trapped inside the cotton fibers.

Charging ports are tiny, but the cotton fibers are tinier. Make sure to pick these left behind fiber strands out with a tweezer.

9. Rubbing alcohol

Get some rubbing alcohol and soak it with a cotton swab and clean the lightning connector.

Alcohol and spirit have an evaporating effect. That’s why they are used primarily for cleaning phones and electronic boards.

10. Distilled white vinegar

Get some distilled white vinegar.

Vinegar has a cleansing effect. Mix it with the distilled water and try to clean the port. Use a swab with a needle.

11. Use old fabric

Lay an old t-shirt over your charger port and keep it overnight. Old fabrics are worn off and have high water-absorbing quality. 

Keeping the phone in this condition will absorb the moisture.

12. Use Sunlight

Place your phone in the sun, with the charging port facing the sun directly.

Solar heating will evaporate the water molecules and get rid of the moisture completely.

This method is super effective. It can completely get rid of the moisture from the entire device. For maximum impact, take apart all the removable parts.

Place all the parts in the Sunlight for the entirety of the day.

13 Greenhouse effect in your parked car

Every point in this article is a guide to removing the water from the phone. Either by directly physically removing it or using natural elements like heat to change its state.

The greenhouse effect in closed cars has a higher temperature than the environment. If you can keep your phone inside your closed car, the heat inside the car will start to increase the water molecule temperature so much that it will start to escape the charging port and it will dry in a few hours.

Keeping your phone inside a closed car to remove the water from the phone’s charging port is the most effortless and effective way. In winter closed parked cars can help keep hands warm for typing as well as for work on the go.

You can just keep your wet phone in off mode inside the car, close the windows, move out, and let the greenhouse effect take care of the moisture in your phone. This works only in the daytime, even more in sunlight than in the shade. Repeat this 2 or 3 times. Keep the phone inside a closed car open after a few hours to let the moist air out and close the car again.

14. Heat using a hairdryer(Be careful)

Use a hairdryer to blow hot air into the charging port. A constant push of hot air will start to heat the port and the air inside it.

This external heat source will heat the water drops inside the port and completely dry the lightning port. 

Use this step cautiously. Avoid too much heat as it might damage the surface of your device. 

15. Just wait for the water to fall out of its own accord

Keep the phone turned off for a few hours, and if you see the signs of perished water, turn it on. Check the warning notifications, if any.

How to get the moisture out of your Android phone’s charging port?

You can use a small needle to clean the USB charging port on your device. You may also need to dry the charging port with a rag or some other means. 

The latest Android devices have a liquid detection feature that, on detecting moisture, flashes a moisture notification.

Most liquid drops are minute in size, which forces the smartphone to indicate that the port is wet, and the android system will detect it. 

Now that your phone is operational you can start making calls, and installing apps.

How to remove water from the iPhone charging ports?

The first step is to remove the apple lightning cable or the lightning accessory and locate the water in the iPhone charging port. 

Do this by searching for a wet area near the port and placing a towel underneath the iPhone.

The phone can still give you moisture notifications even when completely dried. In that case, check your lightning connector.

Try disconnecting the lightning connector to disable moisture notification.

iPhone XS, iPhone Xs Max, and iPhone XR are water-resistant phones. All these iPhone models don’t get impacted by a small amount of moisture. In case they fail to turn on, contact customer support immediately.

How do I clean the charging port on a Samsung phone?

Samsung Galaxy smartphone and other android devices are capable of showing moisture warning messages or liquid detection alerts.

Whether it’s the Samsung S10 or Galaxy S8, both models are water-resistant. 

To clean the charging port of a Samsung smartphone. Use a dry cloth or towel to remove the water from the surface.

How to get water out of the phone’s charging port without rice?

Use the below methods instead of rice.

#1. Use a dry towel

Grab a dry towel and clean the phone charging port. Soak the spot of any residual water.

#2. Contact customer support

Search for the customer support number on the phone box and try to contact them using other phones.

#3. Remove any debris stuck inside the charging port

Use any of the above ways out of these 15 easy ways to clean the lightning port.

What is inside the phone’s charging port?

Inside your device’s charging port, a sealing gasket prevents any moisture from seeping into the phone. All the latest phone charging ports get manufactured this way.

So, when your phone charging port gets damaged, don’t worry if your device supports wireless charging.

For the time being, you can use this facility but prefer it in case of emergencies only. The moisture inside the phone might damage the phone panel.

Can water in the phone charging port damage it?

No, it cannot because the water in the charging port of mobile devices (phones, tablets, etc.) is a common occurrence. And such water will not affect any functions.

But, plenty of water in contact with the charging port for a long duration can inflict permanent damage.

What are the advantages of water-resistant phones?

Water-resistant phones can save your repairing costs that occur from moisture or spillage damage. If a wet climate has damaged your previous due to the moisture. It might be the right time to go for a water-resistant phone with wireless charging.

Recent articles